Prevents machining defect by suffering from chip biting
During the high speed cutting process for aluminum, there might be a risk of chips suddenly biting during ATC.
Our system prevents a machining defect by detecting vibrations in the tool caused by chips biting against the tool taper.
The ATC Run-Out Detection System can be installed only on the following applicable models by our service technicians.
Installation may not be possible on some models, so please check in advance.
Installation process
Site visit appointment
Please contact us by phone or email to schedule a suitable day and time for a site visit.
Preliminary check
A service technician will visit your site to check various pre-installation items, including identifying the model and available I/O ports, checking the ladder, and identifying the controller position.
Estimate
An estimate will be provided covering the identified specifications based on the Preliminary check.
Installation work
We supply the sensors (including brackets), controller, and ladder and perform the installation work.
Confirmation and handling instructions
After installation, the system is tested and operating instructions are provided.